← All tools
Shadow lamp
Upload a picture, or describe it and let the AI draw it. The tool works out the cut-out wall that, around a small light held at the centre, casts that silhouette large on the wall, then gives you the print-ready STL files.
Drop a picture here, or try the sample.
Good to know
- The default light is the small push-button light sold in lots for model kits and lanterns (3 AG3 cells, LED at the tip, about 30 mm long): no wire, no soldering. It clips in at the centre, LED toward the wall, button toward you.
- You can also wire a bare wide-angle LED, the “straw hat” kind (120 to 140°), to a USB port: a 22 Ω resistor in series for the 8 mm, 100 Ω for the 5 mm. An ordinary round LED shines straight ahead: the shadow is then narrow and dark at the edges.
- The light holder is a C-shaped plate: its foot slides into the slot of the centre post, its upright runs along the wall and its head comes back to the centre. Everything that holds the light stays behind the LED and does not block it.
- The upright draws a thin line on the wall. The tool turns it toward the darkest part of the picture; you can pick its direction under “Light, holder and mounting”.
- Measure your light: the diameter of its body and the distance from the shoulder to the LED chip set the grip and how true the shadow is.
- Print the lamp base down, in dark opaque filament, with three walls; the holder prints flat. Turn supports on if the wall has large windows.
- The further the LED is from the wall, the more even the shadow and the better lit its edges; the lamp is then deeper. Keep fine lines near the centre.
- The picture is never uploaded: everything runs in your browser. Only the description you give the AI goes to the server.