SKU UBF-GEN-000173 · Multi-brand
Perfect if you want to eliminate vibrations from your printer. This is a homemade spool holder. Perfect if you want to eliminate vibrations from your printer. This is a homemade spool holder. You need 3 screws to fix it on a shelf or on the ceiling. Tested, works properly. Use two ball bearings to fit it in the perno_06. Write to me for any questions or tips. Thanks Print instructions PLA or ABS, 0.3 layers. Support needed. I printed "cuneo-06" horizontals because it is more strong, but you can try to print it vertically for quality. 29 Sept 2020: Updated "tieni filo" with some improvement
Material properties are indicative, measured on standard test specimens — not a guarantee for every use.
Made on demand in Canada
No model has been confirmed yet for this part.
Confirm your brand and model. We only answer from what we actually recorded.
Select your model to see the answer.
The 3D model loads on demand, so the page stays fast on mobile data.
33.0 × 28.0 × 28.0 mm
Open design by etasca, Creative Commons — Attribution licence. · original model
Cosmetic or non-load-bearing part. Failure has no safety impact.
Fit confidence
Source claimWhy we believe this part fits
AI suggestions are never used as engineering certification. “UbFixit Verified” requires a physical fit test on the real product.
