SKU UBF-GEN-000121 · Multi-brand
Belt clip and case for the Alpharad Club Booster V2 Remote. Both are intended to be printed in TPU. Created a belt clip & case for the Alpharad Club Booster V2 Remote. Disclaimer that the prints in the pics above are printed in PLA for fitting and testing. Both are intended to print in TPU. Case should be printed laying down, instead of standing up. Clip should be printed with supports for the locking mechanism- same orientation as seen in model picture. Suggestions: -use more infill with TPU (60-100%) -at least 4 walls. -most speeds set to 30mm/s -retraction length = 7mm
Material properties are indicative, measured on standard test specimens — not a guarantee for every use.
No model has been confirmed yet for this part.
Confirm your brand and model. We only answer from what we actually recorded.
Select your model to see the answer.
Open design by Jonkswa, Creative Commons — Attribution licence. · original model
Cosmetic or non-load-bearing part. Failure has no safety impact.
Price on request
Taxes calculated at payment.
Fit confidence
Source claimMade on demand in Canada
Why we believe this part fits
AI suggestions are never used as engineering certification. “UbFixit Verified” requires a physical fit test on the real product.
