SKU UBF-GEN-000152 · Multi-brand
End cap to support the bar that clothes hang on for 3-wire ClosetMaid shelves The ClosetMaid shelving that was installed in our house uses a third wire that the clothes hangers can slide on. That bottom wire relies on the end caps to support the weight and stop clothes from sliding off the end. We reconfigured our closets and needed on more endcap, but I couldn't find them for sale anywhere. Printed in generic PLA, but if it doesn't hold up, I'll try printing a new one in PETG.
Material properties are indicative, measured on standard test specimens — not a guarantee for every use.
Made on demand in Canada
No model has been confirmed yet for this part.
Confirm your brand and model. We only answer from what we actually recorded.
Select your model to see the answer.
The 3D model loads on demand, so the page stays fast on mobile data.
15.1 × 68.2 × 15.0 mm
Open design by Ben Berry, Creative Commons — Attribution — Share Alike licence. · original model
Cosmetic or non-load-bearing part. Failure has no safety impact.
Fit confidence
Source claimWhy we believe this part fits
AI suggestions are never used as engineering certification. “UbFixit Verified” requires a physical fit test on the real product.
