SKU UBF-GEN-000076 · Multi-brand
Replacement corner feet for the wire frame trays used in commercial glass washers. An exact replica of the plastic feet that come on the wire glass wash racks used in bars and restaurants. We had a tough time getting hold of replacements and rather than buy a whole new set of plastic trays, I figured I could print these for next to nothing. I drew up the design in Fusion 360 as an exact replica of the originals, but removed the filleting on the bottom edge to make it easier to print. I experimented with materials: PLA is a no go as it will soften and warp in the machine Nylon is strong but I found they took on water and rapidly deteriorated (also expensive) ABS works well if you're used to working with it, but the geometry is prone to warping. I had best results with PETG, printed with a 0.6 nozzle and 0.3 layers, printed quickly and it's nice and stiff so they clip on nicely. I had a super cheap spool of unbranded brown box Chinese “white” PETG on the shelf that prints a nasty off-white/cream colour, but I found this actually gave the best results for this job.
Material properties are indicative, measured on standard test specimens — not a guarantee for every use.
Made on demand in Canada
No model has been confirmed yet for this part.
Confirm your brand and model. We only answer from what we actually recorded.
Select your model to see the answer.
The 3D model loads on demand, so the page stays fast on mobile data.
168.0 × 14.0 × 168.0 mm
Open design by Lee Roberts, Creative Commons — Public Domain licence. · original model
Cosmetic or non-load-bearing part. Failure has no safety impact.
Fit confidence
Source claimWhy we believe this part fits
AI suggestions are never used as engineering certification. “UbFixit Verified” requires a physical fit test on the real product.
