SKU UBF-KIT-000110 · KitchenAid
This is a replacement coupler for the KitchenAid blender model KSB4028BM. This is a replacement coupler for the KitchenAid blender model KSB4028BM. I printed it as solid walls using PC, and it is working great. I don't suspect this part is put under a lot of stress. I made it as close to the original as I could. It was a bit of a tight fit, but I'd rather that over lose. Print it upside down with supports. Push something like an allen key through the bottom screw hole and the support pops right out. I don't have a paid subscription to Shapr3D, so the resolution is lower than I'd like. However, this part isn't really seen and it still fits even though there are facets. I hope it works for you!
Material properties are indicative, measured on standard test specimens — not a guarantee for every use.
Each model below carries its own fit confidence and the evidence behind it.
Note: Claimed by the source listing; not verified by UbFixit.
Claimed by the source listing, not yet verified by UbFixit. See the listing
Confirm your brand and model. We only answer from what we actually recorded.
Select your model to see the answer.
The 3D model loads on demand, so the page stays fast on mobile data.
40.5 × 40.2 × 26.8 mm
Open design by Joe Kaiser, Creative Commons — Attribution licence. · original model
Mechanical function without safety implication (clips, latches, guides, knobs).
Fit confidence
Source claimMade on demand in Canada
Why we believe this part fits
AI suggestions are never used as engineering certification. “UbFixit Verified” requires a physical fit test on the real product.
