SKU UBF-KIT-000115 · KitchenAid
The knob on my family's stand mixer broke so I designed a new one to replace it. This is a replacement knob for the KitchenAid stand mixer. It was designed with tight tolerances to eliminate the need for glue, I used a hammer to get the screw part inside. supports are needed around the edge. Don't forget to like and post a make.
Material properties are indicative, measured on standard test specimens — not a guarantee for every use.
Made on demand in Canada
No model has been confirmed yet for this part.
Confirm your brand and model. We only answer from what we actually recorded.
Select your model to see the answer.
The 3D model loads on demand, so the page stays fast on mobile data.
18.5 × 18.5 × 22.0 mm
Open design by Pixel3D, Creative Commons — Attribution licence. · original model
Cosmetic or non-load-bearing part. Failure has no safety impact.
Fit confidence
Source claimWhy we believe this part fits
AI suggestions are never used as engineering certification. “UbFixit Verified” requires a physical fit test on the real product.
