SKU UBF-GEN-000164 · Multi-brand
Replaces a broken clip I created this for work, we have an imaging station that we custom made 180 cables for. Almost half of them have clips broken through normal wear and tear for the last 8 years and current project needs consistent network connection to work properly. It mounts on the back of the rj45 connector and becomes the clip to hold it in place. Much easier solution than re-terminating the cable ends.
Material properties are indicative, measured on standard test specimens — not a guarantee for every use.
Made on demand in Canada
No model has been confirmed yet for this part.
Confirm your brand and model. We only answer from what we actually recorded.
Select your model to see the answer.
The 3D model loads on demand, so the page stays fast on mobile data.
18.0 × 19.5 × 11.5 mm
Open design by Xypher2000, Creative Commons — Attribution — Share Alike licence. · original model
Cosmetic or non-load-bearing part. Failure has no safety impact.
Fit confidence
Source claimWhy we believe this part fits
AI suggestions are never used as engineering certification. “UbFixit Verified” requires a physical fit test on the real product.
