SKU UBF-SUB-000124 · Subaru
This was for a Subaru but it is used in a large variety of vehicles. I printed my clips out of abs and glued them together with superglue! All super glue is not created equal in the case of abs locktight works wonders. These clips were used to put the panel back in the drivers side foot well where the first 2 became bent! Good luck!
Material properties are indicative, measured on standard test specimens — not a guarantee for every use.
Made on demand in Canada
No model has been confirmed yet for this part.
Confirm your brand and model. We only answer from what we actually recorded.
Select your model to see the answer.
The 3D model loads on demand, so the page stays fast on mobile data.
16.0 × 16.0 × 19.5 mm
Open design by Karagula, Creative Commons — Attribution licence. · original model
Cosmetic or non-load-bearing part. Failure has no safety impact.
Fit confidence
Source claimWhy we believe this part fits
AI suggestions are never used as engineering certification. “UbFixit Verified” requires a physical fit test on the real product.
