SKU UBF-GEN-000104 · Multi-brand
Wheel piece replacement for a Wasco 12L vacuum. The wheel piece of my Wasco vacuum broke after accidentally falling from a table. I designed this as a replacement, while imitating the original piece. This fits the 12L Wasco vacuum (model MWD192) from Wasco Clean. I reuse the original screw to fasten it to the vacuum. Print settings: Filament: Any Nozzle: 0.4mm Layer Height: 0.2mm Infill: 25% Support: None Estimated Material: 38.54g Estimated Print Time: 1 hour 7 min
Material properties are indicative, measured on standard test specimens — not a guarantee for every use.
Made on demand in Canada
No model has been confirmed yet for this part.
Confirm your brand and model. We only answer from what we actually recorded.
Select your model to see the answer.
The 3D model loads on demand, so the page stays fast on mobile data.
56.0 × 96.3 × 33.7 mm
Open design by Oblimix, Creative Commons — Attribution licence. · original model
Mechanical function without safety implication (clips, latches, guides, knobs).
Fit confidence
Source claimWhy we believe this part fits
AI suggestions are never used as engineering certification. “UbFixit Verified” requires a physical fit test on the real product.
