SKU UBF-WHI-000059 · Whirlpool
Replacement part for this: https://www.amazon.com/WPW10195622-Dishwasher-Dishrack-Stop-Clip/dp/B09P8D54XJ/ This clip broke on my dishwasher. It prevents the top rack from leaving the dishwasher. First I modeled and printed the steel railing to make sure the original clip would fit in my modeled rail. Then I designed a replacement clip that was easily 3D printable. I printed this in Polymaker ASA which can withstand the dishwasher hot washes and drying cycles. Printed as oriented for strength. Needs supports but no one will ever see where the supports touch the part. After three months of daily dishwasher use it is still functioning as designed. Here is the replacement part: https://www.amazon.com/WPW10195622-Dishwasher-Dishrack-Stop-Clip/dp/B09P8D54XJ/
Material properties are indicative, measured on standard test specimens — not a guarantee for every use.
Each model below carries its own fit confidence and the evidence behind it.
Note: Claimed by the source listing; not verified by UbFixit.
Claimed by the source listing, not yet verified by UbFixit. See the listing
Confirm your brand and model. We only answer from what we actually recorded.
Select your model to see the answer.
The 3D model loads on demand, so the page stays fast on mobile data.
31.0 × 14.9 × 14.0 mm
Open design by Bert, Creative Commons — Attribution — Share Alike licence. · original model
Cosmetic or non-load-bearing part. Failure has no safety impact.
Fit confidence
Source claimMade on demand in Canada
Why we believe this part fits
AI suggestions are never used as engineering certification. “UbFixit Verified” requires a physical fit test on the real product.
