SKU UBF-DYS-000016 · Dyson
Replacement part for Dyson DC14 (and others) A replacement part for the Dyson DC14 upright vacuum cleaner. This part replaces the wand release catch. Printing: Printed with ribs facing up Build-plate supports for at least 35 degree angles PLA, 0.15 layer height resulted in easy-to-remove supports and good fit 3 perimeters
Material properties are indicative, measured on standard test specimens — not a guarantee for every use.
Made on demand in Canada
Each model below carries its own fit confidence and the evidence behind it.
Note: Claimed by the source listing; not verified by UbFixit.
Claimed by the source listing, not yet verified by UbFixit. See the listing
Confirm your brand and model. We only answer from what we actually recorded.
Select your model to see the answer.
The 3D model loads on demand, so the page stays fast on mobile data.
52.6 × 118.1 × 24.0 mm
Open design by cedarrapidsboy, Creative Commons — Attribution licence. · original model
Cosmetic or non-load-bearing part. Failure has no safety impact.
Fit confidence
Source claimWhy we believe this part fits
AI suggestions are never used as engineering certification. “UbFixit Verified” requires a physical fit test on the real product.
